VoxShaper drafts blueprints for Minecraft: spheres and domes, tubes, cones, circles and rings, along with roofs, arches, vaults, bridges and staircases. Smoothed edges make curves look round, even in a world made of blocks.
How it works
Pick a basic shape from the menu at the top, from simple geometric solids to roofs, vaults, bridges and staircases. Set the dimensions on the left and, if you like, the smoothing on the right. The preview in the middle follows every change instantly.
Happy with the result? Download it from the title bar, as a schematic for Litematica, WorldEdit or the Structure Block, or as a 3D model. Or build it yourself, layer by layer, in the 3D view as well as in the floor plan.
Smoothed edges
Instead of stepping every curve out of full cubes, VoxShaper uses stairs, slabs and other partial blocks wherever the surface runs shallow enough. The result is a calm silhouette rather than jagged steps. If you like, trapdoors or seat cushions sit on top as a shallow step in between.
Open, no account
No account, no sign-up, nothing to unlock: every feature is open to everyone. Your settings are stored only in your browser.
Building straight and curved stairs in Minecraft
Made of full blocksMade of half slabs
A curved staircase runs along a round tower wall, around a courtyard or sweeps up to an entrance. By hand it is hard to get right: every step should be equally deep along the walking line, wider on the outside and narrower on the inside. VoxShaper places the steps for you and shows you every layer.
Setting the shape
The height sets how many steps the staircase has. The step depth sets how many blocks deep each step is in the middle of the stair width. Together they give the run length. The curve bends that run: at 0° the staircase is straight, at 90° it makes a quarter turn, at 360° a full circle. VoxShaper works out the inner radius and shows it below the slider, so you can fit the staircase into a tower.
With half steps every step rises half a block, so you walk up without jumping. With full blocks every step is a whole block high. The support sets what lies below the steps: nothing, a thin support that follows the slope, or solid masonry down to the ground.
Build or export
Rebuild the staircase layer by layer or download it as a schematic for Litematica, WorldEdit or the Structure Block. For more than one full turn, use the spiral staircase.
